Classic AutoAir Perfect Fit-Elite Series Betriebsanleitung PDF herunterladen (Seite 12)

Locate the Defrost / Heat Duct Assembly.

Attach to evaporator using (2) #10 x 5/8 pan

head Philips screws. Be sure that the S-clips

are pressed over the rear flange. This helps

secure the duct assembly.

Locate 2” dia flex hose (1) piece 2’ long and

attach it to right outlet as shown.

Find (1) piece of 2” dia. flex hose 3’ long and

attach it to left outlet. Route hose down and

behind the micro switch assembly.

Locate wire harness from the evaporator electric actuator and attach to the (2) micro switches.

Refer to the wiring diagram on next page.

Attach Wire Harness supplied in unit to the blower switch. Route harness through the control

opening. Attach wire harness to left micro-switch on Defrost Duct assembly. Route harness

across top of the unit and hookup the resistor, and blower motor. Route the blue clutch wire over

evaporator and out through hole in the firewall block off plate.

BLUE WIRE FROM BLOWER

SWITCH

BLUE WIRE TO THE

THERMOSTAT

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Keine Kommentare

Classic AutoAir Perfect Fit-Elite Series Betriebsanleitung Seite 12